.Leading electrical team
.Maintaining the power availability for AC unit.
.Synchronization of generators.
.Making sure the power is uninterrupted 24/7 for base as well as work shop areas.
.Ensuring the safe operation in maintenance workshop. i.e milling grinding welding cutting etc.
.Supervising batching plant operation and its independent 3-phase power generator.
(most imp)
trouble shooting and rectifying electrical and electronics faults in heavy earth moving machinery.

• Efficiently lead and mentored project teams; organized and managed the Electrical section as necessary from the receipt of tenders to the completion of final accounts.
• Ensured that sub-contractors are supervised and their standard of work is acceptable and in compliance with recognized safety practices and agreed specifications.
• Controlled and effectively managed all the sections operations through regular site visits as necessary and in accordance with frequencies considered essential in order to assess progress, safety and quality and to give instruction or advice.
• Liaised with departmental staff, client departments, contractors, suppliers and statutory authorities in matters relating to work as appropriate.
• Monitored and controlled the day-to-day finance of all Electrical operational contracts.
• Maintained and fostered contacts with consultants, contractors, vendors and material suppliers.
• Served as an interface between the Electrical Engineering team and internal clients to facilitate interdepartmental relations.
• Assisted with the development of new electrical engineering standards and maintained and improved existing standards and guidelines.
• Acted as a subject matter expert regarding some electrical engineering activities ensuring that project needs and objectives were met.
• Prepared electrical-related scope documents, exhibits, budgets, specifications, and schedules.

• Observed the overhauling, maintenance & repair of Siemens, ABB, and Caterpillar Equipment.
• Followed the ANSI/NETA ATS-2013 & IEEE standards for diagnose/locating while working in testing bay and accessing permit to reinstall on board once the repair has been done.
• Efficiently conducting transformer routine test while working with high voltage transformer: 132kv.
• Gained expertise in carrying out various types of tests: Power factor tests, moisture content test, winding resistance test, core loss test, meager test Dielectric tests, and temperature rise test of transformer.
• Gained precision and accuracy in working with low medium and high voltage motors run at potentially explosive gases or vapors (LPG/LNG vessels) i.e. EX (E) & EX (D) motor’s repair and made deliveries to client with full responsibility and accountability.
• Carried out the measurement of impedance (Short circuit tests)/Measurement of no load (Open circuit tests).
• Managed the overhauling and bearing replacement of 300-500kw squirrel cage ABB motors.
• Handled the varnishing and rewinding and replacing of the sensors in the poles for routine plug and play tests for High current 1000 amp. Caterpillar alternator.

• Estimating the material cost. Communicating and coordinating with sub-contractors as well as client/consultant satisfaction.
• Completed the task within first attempt and within TAT and confirmed every floor is completing without any lag or quality compromise.
• Laid down the Building Management System BMS by installing of electrical networking according to given drawing.
• Ensured appropriate wire installation as per British Society of Construction Law.
• Carried out the inspection of elevators and lifts installing company.
• Reconfirmed the spot of electrical points and left additional sets of wire in case of first’s failure before slab concrete.
• Helped the workers in increasing their work-related knowledge by describing the concept of Real power (P), reactive power (Q).
• Looked after the installing of BTU meters and Electrical power meters in respective addresses.
• Nullified the adverse effect of power factor by installing and maintaining the capacitors bank after the supply to electrical company.

• Met and explained clients about the power requirement along with handling administrative task.
• Safely estimated the material of LED’s Sign boards, independent powered Uni-poles and preferred the clients LED’s over conventional NEON signage.
• Looked after the installing, adjusting and recommending Electrical Timers for signs.
• Ensured the smooth operation throughout the job by operating CNC routers, laser cutters.
• Carried out the installation of AVR with correct “wae-delta” connection to the industrial unit.