Crop Picture
NOTE: Do not upload any image that violates our Picture Policy. Doing so will result in the removal of the concerned image without prior notification.
概要
Want to be placed in a well reputed company to show my skills and abilities and want to hit the position where I can take the crucial decisions of my organization with my experience and idea.
工作经历
Design engineer embedded
Excellent knowledge of electrical embedded systems and product development.
▪ Experienced on following product development stages:
→Schematic design
→PCB Stuffing
→Compose written reports to fully document all project activity.
▪ →Prepare and deliver technical presentations to a variety of small or large groups.
→Reverse and re-engineering.
→Components Selection
→PCB Design
→Hardware testing and debugging.
→Hands on knowledge of Hardware Design Review and Signal Integrity check of PCB layout.
→Lab Equipment’s Oscilloscope, Logic Analyzer, Logic Ports, Spectrum Analyzer,
Programmers, Digital LCR meter, Avionic Communication Bus Analyzer (1553, ARINC 429)
→Protocols understanding UART, RS232 & RS 485, SPI, I2C
→Tools IDE & IPE: CodeBlocks, Xilinx STM32CubeMx, STM32Cube Ide, System Workbench for
STM32, MikroC Pro for ARM, MikroC for PIC, MikroC for AVR, DEV C, Arduino,
STM32 link Utility, Keil, MikroC Pro for ARM, MikroC for PIC.
Associate engineer embedded
Performs routine or entry-level engineering tasks embedded systems programing.
▪ PCB Designs, Proteus/Altium Simulation
▪ Analog and Digital circuit Designing.
▪ Verification of schematics & PCBs
▪ Hardware Testing, Understand FPGA and Micro Controller Based designing.
▪ Fault Detection, Troubleshooting & Understand PME.
▪ Hands on experience in the languages C/C++
Service Engineer
