Crop Picture
NOTE: Do not upload any image that violates our Picture Policy. Doing so will result in the removal of the concerned image without prior notification.
概要
I have completed my bachelors in Mechanical Engineering from NED University. During these four years of bachelors, I took part in Engineering Projects and events, from where I have learned the ground realities of the system. Also, I have certification in designing courses and this allow me to design my Final year Project. (To design and fabricate solar powered GPS guided motorized float)
Currently, I am working as a Utility Engineer in Soorty Denim Enterprises. I have been working here for the last one year. In the first six months I was assigned in Mechanical Maintenance department where I have learned about Mechanical faults (bearing failure, shaft misalignment, pressure regulating valve maintenence and so on).
I have also worked in the Errection of Effluent Treatment Plant in soorty Denim Enterprises. ETP plant have a processing capability of about 150 cubic meter per hour. The plant mainly consists of first screener, submerged pumps, neutralization tank, circulation pumps, membrane filters, biological tank, diffusers, sedimentation tank, belt press filter, ionizer and micro filter etc.
项目
工作经历
Utility Engineer
I am working as a Utility Engineer. My job discription is as follows.
Working on Engineering projects.
Maintain the maintenance record of utilities(boiler, compressor) and other related activities.
Keep Manger informed about the Maintenance work
Trainee Engineer
I am working as a Trainee Engineer in talent development department. It all starts with brief orientation of the company, then I have completed 6 months training period in mechanical maintenance department. Currently, I am involved in Mechanical Errection, that is installation of effluent treatment plant in the company.
Internee
I have worked as an internee in Hinopak Motors company and worked under the supervision of Assistant Manager Chassis department, where i have done project to increase the productivity by removing bottlenecks and in order to accomplish the task i have made check list of all operations done on chassis line and note their respective timing.
Internee
I have worked as an internee in Atlas Autos Limited and worked under the supervison of Assistant Manager Clutch department, where i have done project to design a lean pipe system so that the productivity will increase by removing the bottlenecks at the end of assembly line.
